phone: +39-011-988 2251 fax: +39-011-988 1358 http://gpsemi.it/pdf/getg0105.pdf getg0105 phase controlled scr plastic case dc power supply ac drives voltage up to 600 v average current 1050 a surge current 15 ka blocking characteristics characteristic conditions v rrm repetitive peak reverse voltage 600 v v rsm non-repetitive peak reverse voltage 700 v v drm repetitive peak off-state voltage 600 v i drm repetitive peak off-state current, max. v drm , single phase, half wave, tj = tjmax 50 ma i rrm repetitive peak reverse current, max. v rrm , single phase, half wave, tj = tjmax 50 ma on-state characteristics i t(av) average on-state current sine wave,180 conduction, th = 55 c 1050 a i t(rms) r.m.s. on-state current sine wave,180 conduction, th = 55 c 1649 a i tsm surge on-state current non rep. half sine wave, 50 hz, v r = 0 v, t j = t jmax 15 ka i2t i2 t for fusing coordination 1125 ka2s v t(to) threshold voltage t j = t jmax 0.87 v r t on-state slope resistance t j = t jmax 0.238 m w v tm peak on-state voltage, max on-state current i t = 2900 a , tj = tjmax 1.56 v i h holding current, max t j = 25 c 600 ma i l latching current, typ t j = 25 c 1000 ma triggering characteristics v gt gate trigger voltage t j = 25 c, v d = 5 v 2.5 v i gt gate trigger current t j = 25 c, v d = 5 v 190 ma v gd non-trigger voltage v d = 67% v rrm , t j = t jmax 0.25 v p gm peak gate power dissipation pulse width 0.5 ms 10 w p g(av) average gate power dissipation 2 w i fgm peak gate current 3 a v fgm peak gate voltage (forward) 20 v v rgm peak gate voltage (reverse) 5 v switching characteristics di/dt critical rate of rise of on-state current t j = t jmax 200 a/s dv/dt critical rate of rise of off-state voltage t j = t jmax 500 v/s t q turn-off time, typ t j = t jmax , i t = 320 a, di/dt = -12.5 a/s s vr = 100 v, vd = 67% vdrm, dv/dt = 20 v/s thermal and mechanical characteristics r th(j-c) thermal resistance (junction to case) double side cooled 0.034 c/w r th(c-h) thermal resistance (case to heatsink) double side cooled 0.010 c/w t jmax max operating junction temperature 125 c t stg storage temperature -30 / 125 c f clamping force 10% 9.0 kn mass 85 g document getg0105t002 value green power solutions srl web: www.gpsemi.it e - mail: info@gpsemi.it
phase controlled scr getg0105 ordering information getg0105-vvgl vv : blocking voltage / 100 (e.g. 06 for 600 v) g : trigger lead type ( s = straight t = twisted blank = no leads) l : trigger lead lenght x 100mm ( 3 - 4 - 5 - 7 blank = no leads) document getg0105t002 0 2 4 6 8 10 12 14 16 1 10 100 i tsm [a] number of cycle current pulses [n] maximum surge current d.s. cooled 0 500 1000 1500 2000 2500 0 0.5 1 1.5 i t [a] v t [v] on - state voltage drop t j =t jmax 0 0.005 0.01 0.015 0.02 0.025 0.03 0.035 0.04 0.001 0.01 0.1 1 10 100 z th(j - c) [ c / w] time [s] thermal impedance (j - c) 50 60 70 80 90 100 110 120 130 0 200 400 600 800 1000 1200 heatsink temperature [ c] i t [a] current rating - sine wave 180 90 120 60 30 0 200 400 600 800 1000 1200 1400 1600 1800 0 200 400 600 800 1000 1200 p f [w] i t [a] power loss - sine wave 180 120 90 60 30 i n the interest of product improvement green power solutions reserves the right to change any specification given in this data sh eet without notice. 0 500 1000 1500 2000 2500 0 0.5 1 1.5 i t [a] v t [v] on - state voltage drop t j =t jmax dimensions mm gate aux. cathode
|